Is it possible to create a cubic slice?

JamesBlack
JamesBlack Posts: 3 New Member
in Leapfrog
Hi,

I was wondering if there is a way to have 2 slices active at the same time, to cut a cube shape out of my ground model to show the geology in a specific area of the model.

Thanks in advance
Tagged:

Comments

  • DavidWatkins
    DavidWatkins Employee Posts: 48 mod
    @JamesBlack,

    You can't have two active slices at the same time, but as a work around you could try a few possible work arounds:

    - Evaluate your GM onto a block model and use the index filters to create a subset / sliced block model (dynamic slicing).

    - Make a copy of your GM and add a lateral extent to its boundary using a polyline based on the area that you want to remove (limited to a single prechosen slice).


    I hope that helps, Cheers
    David

Categories