How can i make my extruded meshes deeper than 10km?

JoãoBittencourt
JoãoBittencourt Posts: 1 New Member
in Leapfrog

Im making a extruded mesh from a polyline, to drape a image on it. However, i need the mesh to be 40km deep to fit the image, but the tool only let me extrude to 10km. Is there any other way to achieve that?

Tagged:

Best Answers

  • PrachiChitkara
    PrachiChitkara Posts: 459 admin
    Answer ✓

    Hey! Were you able to edit it to 40km? Is it limiting it to 10km if you follow these steps - https://help.seequent.com/Geo/2024.1/en-GB/Content/meshes/extruded-mesh.htm?Highlight=mesh

  • PrachiChitkara
    PrachiChitkara Posts: 459 admin
    Answer ✓

    There appears to be no limit if you use Extrude to elevation mode and specify the Bottom elevation 40km below the polyline Z

Categories