Good Day, i have attached an image of an issue i am having with LF. I am trying to create a geological model from borehole data. I have known points however LF does not interpolate between some of these points. See blue arrow in image. I have tried adding in manual manipulations using polylines shown with the block box on…
I'm doing model of big coal deposit that has 2 main coal seams that are intercalated with a lot of clay lenses. So I did my model using Vein System. I need to make a map of total coal thickness and seam roof and floor. How Can I do that from a Vein System volume model?
Dear all, I want to know how to calculate the length, area and volume of each stretch in a combined tunnel model. In other words, how to separate each stretch by the lithology used within the model, and show (either through a table or a report) its length, area and volume. Many thanks!!
In the mineralization domain, there are Au, and Cu. Here I use eq(Cu+Au) to act as cut-off grade (CoG) to do Mineral Resource Estimation. eqCuAu means Cu +equvalent to Cu from Au when using CoG=0%, there are invalid in Cu grade and contained Cu; when using CoG=0.2%, there are still some invalid in Cu grade and contained…
Does anyone know the easiest way to convert from the AGD84 to GDA94 coordinate system? I registered my maps and cross-sections in Leapfrog under the AGD84 system, then exported them and uploaded them into a GDA94 system, but they still don’t align correctly. Any advice on what might be causing the issue or how to resolve…
Hey there, Anyone knows how can I create an accumulate length or a total length for different units for drillholes, using Leapfrog Geo or Edge? Thanks
Hey, there - I am very new to the software. I have a question that's related to topography. I have sucessfully been able to get topography to import as a proper surface. Other times, it comes in as a block. I'm not sure why this is happening. I have tried doing .grd, .tif, and .asc files. All files are to the same extent…
I'm creating a cross section with a block model of a mag survey (discrete colourmap). My values are all quite small (3 decimal places) but the legend on the section will only display whole numbers. I can't see where I can add decimal places. Thanks for any help!
Using the drilling prognoses tools the leapfrog3d help segment suggests that planned drill holes can be evaluated against a block model: Planning Drillholes (leapfrog3d.com) There are two columns shown there, Au and GM. I have planned drill holes and I need to create a table of the approximate lithology and grade (from our…
It looks like you're new here. Sign in or register to get started.