-
¿Es posible exportar un modelo geológico de un proyecto a otro sin convertirlo en un modelo estatic?
Tengo un modelo de alteración y otro litologico en dos proyectos separados, y quiero dejar ambos modelos en un solo proyecto. Leapfrog me permite exportar solo los solidos (dxf, msh,…), pero yo quiero que el modelo sea dinamico en el proyecto donde pretendo copiarlo. Creo que leapfrog no lo permite aun, solo he intentado…
-
Modelo Geológico - Transversais
Gostaria de saber se é possível que o modelo geológico seja criado com uma referência diferente de Norte/Sul. Eu tenho uma rodovia de 5 km no sentido nordeste, cortando todo o modelo. Gostaria de fazer cálculos de volume para aterro e corte dentro do Leapfrog, porém o modelo abrange regiões longe do meu trecho de…
-
Geological Model - Linear Works
I would like to know if it is possible for the geological model to be created with a reference other than North/South. I have a 5 km highway in the northeast direction, cutting through the entire model. I would like to make volume calculations for landfill and cutting within Leapfrog, but the model covers regions far from…
-
Fixing CSG error locations
I have had an issue when building a faulted geological model using borehole data. When I developed the initial unfaulted mode, there was no issue at all and it processed fine, however when I use the same data to create a faulted model, several fault blocks do not process correctly, with units sitting side by side instead…
-
Transfer all of a GM user-defined constraints to a new GM using a different drillhole group
Best way to transfer all of an existing GM user-defined constraints, including resolutions, interior/exterior clipping boundaries, variance, sill range, drift, accuracy, etc.. to a new GM within the same project, which is using a different drillhole group and merged tables, using the same column headers. Hence, we need to…
-
Excessive Waiting - Mesh Selection
Hey guys, I'm creating 47 standardized GM's (copy/paste from a single source) for resource classification. These GMs are based on externally extruded wireframes loaded in my Mesh folder. When I create the intrusion, based on surface, and click to select data (image below) it takes 1m30s only to display the available meshes…
-
creating finite faults
I'm trying to create a finite fault for my geological model, but no matter what I do Leapfrog extends the fault all the way out to my GM boundaries. I created my fault by drawing a polyline (to the correct length) but then when the GM creates it as a fault plane, it suddenly extends out. The only YouTube help there is, is…