As I wish to model to a minimum thickness, I must turn off snapping to the hangingwall and/or footwall, or the vein thickness may shrink below my specified minimum thickness. In doing so, the reference plane may be far from the selected interval so that the vein boundaries do not actual cover the entire interval. I've created meshes on the selected intervals to be guides to the reference surface, but this is not a full proof workflow to assure the non-snapped vein will completely cover all the selected intervals. Our current workflow is to review the vein and add hangingwall or footwall intercepts (and snap to them) to force the vein to cover the intervals, but this is time consuming. It'd be nice to have the reference plane snapped to the midpoints of each interval and be assured that the minimum width envelope covers the selected interval. Can this be done without excessive manual digitization?