The most recent content from our members.
I've developed a Leapfrog model to analyze the stability of a tailings dam. The model represents two top green layers as tailings, which have been modeled as vein. The underlying purple layer is sediments, modeled as a deposit. In the model, the tailings (modeled as vein) are expected to form the top layer. However, the…
Hi All, I have nominal 50cm classified lidar data, but upon import of the tif into leapfrog geo as an elevation grid, the smallest triangle size that leapfrog will allow is 3.84. I have the original las data and can confirm that the point density is in fact higher then 50cm. I did not produce the tif myself, so cannot…
I'm trying to create a mesh that is a copy of my topography, but offset 1-2 units above my topography. I have several layers I would like to appear on top of my topography, but I can only drape one layer at a time, as opposed to several. My theory is I can set the elevation of each layer to an offset mesh that is just…
Hi everyone! Currently I'm using Leapfrog Geo/Edge for our shot term nickel operations and I would like to know if there a way to evaluate our reserves below topography, because during evaluation Leapfrog consider the total block, even the proportion of blocks that fall above topography. For operations this is important…
I have a Leapfrog Geothermal model with the standard XYZ extents that make a nice square, but am I able to customize the boundaries? My advisor wants it to look like this (picture attached) and suggested I "cut it to this shape" but I'm not sure how to make the boundaries diagonal. The picture is looking straight down and…
I am trying to drape a GeoTIFF image onto my topography. I used manual georeferencing since my image and topography have different CRS. But my image keeps tilting. The referenced points are correct but my image won't lay flat, and I have no idea why or how to fix this.
It looks like you're new here. Sign in or register to get started.