-
Is it possible to manually draw planes in a scene similar to 3D polylines?
I want to add several planes in my scene to help estimate the locations of faults and boundaries. The 'Show Plane' button is the kind of thing I want but ideally I would be able to add multiple planes and have them stay in the scene in the same way I can draw and save polylines. Is there anyway to achieve this in Leapfrog?…
-
Control on the type of displacement of fault
Hello all, I have 2 faults (non intersecting) in a single model. How I control the displacement of the veins, like 1 will be strike-slip another normal.
-
Ignoring faults in certain (soft rock) lithologies
I am modeling a geological situation in Leapfrog Works 4.0 with several faults, an alpine sedimentary (hard rock) sequence and some small scale soft rock cover (moraine and swamp sediments). As some of the faults also cut through areas wit soft rock cover, the faults do affect also these lithologies. Is it possible to…
-
Fixing CSG error locations
I have had an issue when building a faulted geological model using borehole data. When I developed the initial unfaulted mode, there was no issue at all and it processed fine, however when I use the same data to create a faulted model, several fault blocks do not process correctly, with units sitting side by side instead…
-
Thrurst/reverse faults in Geo...
Faults tool in Geo is a great one, but trying to model a reverse fault is alwas a time-consuming task; on the other hand, most of the times (depending on data and drilling angles and distribution) normal faults causes the limits of solids between fault block them look as reverse faults. Is there a plan in future releases…
-
creating finite faults
I'm trying to create a finite fault for my geological model, but no matter what I do Leapfrog extends the fault all the way out to my GM boundaries. I created my fault by drawing a polyline (to the correct length) but then when the GM creates it as a fault plane, it suddenly extends out. The only YouTube help there is, is…